Yes. The Hydro-Pure system can be used to fill dental bottles and other dental/medical equipment that uses distilled quality water in your office. This water will be great for drinking if the Hydro-Pure system is equipped with the Ionizer/Mineralizer cartridge.

Water to the office should always be shut off at night, preventing water damage should any water lines leak. If the office has a water solenoid shut-down system, turn the switch off before leaving for the day. Otherwise, the system can be turned off by closing the inlet feed valve. (Cold Water line)

The only requirements for installing a Hydro-Pure System are cold water (3/8” valve-stop cold water supply) and a nearby drain. Most offices install the Hydro-Pure system into the base cabinet of the sterilization center. No electricity is required for this system unless the water pressure is less than 50 psi. (Water pressure less than 50 psi will need a booster pump)

Changing the filters is not all that hard; however, most dental offices have a trained service technician or maintenance person come in and replace the filters.

There is certainly a huge saving in staff time and convenience. There are no trips to the store for water or expensive water delivery services. The capital investment can be quickly recovered in these cost savings.

The handheld TDS meter is provided for testing the output water weekly. Water should be tested weekly for water quality (TDS) with the TDS meter that was provided with your system. Water quality should meet your autoclave manufacturer’s requirements for TDS. If the product water quality does not meet your autoclave manufacturer’s needs, please refer to the maintenance schedule on page # 13 in your installation, operation, and service manual